Plectrum position: early sound

Loads of accumulated experience

Moderators: David Martin, Iain Purdon, dave robinson, George Geddes

Plectrum position: early sound

Postby me-and-my-shadow » 29 Jul 2011, 20:32

Being a newbie right here, I expect this has already been discussed at length...however
I could never figure out just how to ephasise that Strat bark as heard on the early releases suach as The Savage, FBI, Frightened City etc and Ive been playing since the late 50s. I was enlightened by an enthusiast sometime ago. The bark can be achieved by turning the tip of the plectrum at a slight angle so it addresses the string almost from the plectrum side edge initially. Thats not the whole story though..at the same time the tip of your thumb has to make the slightest contact with the string. OK its not easy..get it wrong and you will completely duff the note all together. I only attempt it if Im feeling confident that I wont mess up....which gets more often as the years go by. :?
me-and-my-shadow
 
Posts: 60
Joined: 26 Jul 2011, 13:47

Re: Plectrum position: early sound

Postby roger bayliss » 30 Jul 2011, 12:27

See 'Whence The Twang' Thread. Probably more so for the early numbers but not so much Top Boost onwards and each tune might have it's own plectrum useage as guitarists we should understand that the way we hit the strings and how is usually the first point of call for 'tone' .
American Pro Series Strat 2017, G&L S500 Natural Ash
User avatar
roger bayliss
 
Posts: 1816
Joined: 15 Sep 2009, 00:15

Re: Plectrum position: early sound

Postby Iain Purdon » 30 Jul 2011, 14:57

David Martin, founder of these boards and former guitarist with Legend, gives a very good demonstration of plectrum technique and how to achieve that (early) sound.

Iain
Iain Purdon
site organiser
User avatar
Iain Purdon
Site Admin
 
Posts: 3343
Joined: 12 Sep 2009, 15:21
Location: Axmouth, Devon

Re: Plectrum position: early sound

Postby me-and-my-shadow » 31 Jul 2011, 12:50

Granted ! . . . . . personally I've always thought it easier to get the early sound rather than the contemporary. The plectrums I use now are nothing like those I used 50s/60s. I tend to cut them down now, the other inovation I use at times (someones going to tell me its old hat no doubt) is to super glue to different grades of pectrum together at circa 90 deg to each other. The benefit is when a softer tone is required, maybe even mid track, I can easily switch from one grade to the other ..and back. J.
me-and-my-shadow
 
Posts: 60
Joined: 26 Jul 2011, 13:47

Re: Plectrum position: early sound

Postby roger bayliss » 31 Jul 2011, 13:21

Thats a good idea actually . Apparently Hank uses george dennis sharps 1.3 mm these days . I found a good 'Sharp' pick that Dunlop makes in Delrin that would make a good substitute and a lot of pro players use them too...

http://www.stringsdirect.co.uk/products ... itar_picks

I have ordered a few to give them a try. I usually tend to stick with Delrin 500 1.14mm but I will try these out.
American Pro Series Strat 2017, G&L S500 Natural Ash
User avatar
roger bayliss
 
Posts: 1816
Joined: 15 Sep 2009, 00:15

Re: Plectrum position: early sound

Postby me-and-my-shadow » 31 Jul 2011, 13:33

Think Id better try these too. John
me-and-my-shadow
 
Posts: 60
Joined: 26 Jul 2011, 13:47

Re: Plectrum position: early sound

Postby me-and-my-shadow » 09 Aug 2011, 20:05

Yep....works for me. Smooths off the top noticably. I like ! J.
me-and-my-shadow
 
Posts: 60
Joined: 26 Jul 2011, 13:47


Return to How To Get "That Sound"

Who is online

Users browsing this forum: No registered users and 60 guests

Ads by Google
These advertisements are selected and placed by Google to assist with the cost of site maintenance.
ShadowMusic is not responsible for the content of external advertisements.