The ShadowMusic Web Community

Sorry if there is an answer to this somewhere here - I did look hard, honest!

I also tried to find it on the link to the Newtone website that Piet gives in his blog but no luck there either

I have been very impressed with the demo recordings of Dave Robinson using this new hardware unit that Piet has put so much research and effort into. A big thanks to him for all his hard work

Thanks in anticipation,

Phil.

Hi Phil

Here's a link to the Newtone kit info. I suggest you email them at the address in the document and they will arrange to send you a Paypal invoice.

http://db.tt/zQTo5st1

Roger

Thanks Roger

Or if you want one built and ready to go contact Ecca

Thanks Keith but I'm actually looking forward to building it myself. I've built all sorts of stuff from amps to effect pedals but have not done any for a number of years. I should be ok as long as the old eyesight is up to it - I'll keep the magnifying glass handy

Phil.

Your'll need a magnifying glass, a steady hand and a small soldering iron because the PCB is a lot smaller than it looks
on the Echotapper site.

Best regards,
BAZ.

bazmusicman wrote:Your'll need a magnifying glass, a steady hand and a small soldering iron because the PCB is a lot smaller than it looks
on the Echotapper site.

Best regards,
BAZ.

Cheers Baz.

Magnifying glass - check
Small Soldering Iron - check
Steady Hand -

I have three kits on order with Newtone. How does the size of the PCB compare with, say, a credit card?

Phil.

Hi Phil

The motherboard is about 1/2in bigger than a credit card in both dimensions. The daughterboard (pre-assembled) is about 1/3 the size of a credit card.

There's a support etc forum here if you're interested

http://www.shadows-talk.co.uk/viewforum ... 3fb9432b22

Roger

Many thanks Roger for the info and link.

Phil.